Not every shop has room for a miter saw station that lives permanently in one spot. This cart was built for exactly that problem: a mobile miter saw station on locking casters, with a saw bay and tool storage built right into it, that can be rolled into place when it’s needed and pushed out of the way when it isn’t.
Sketched at the Saw, Before Any Plywood Was Cut
This build started with the saw itself sitting on a bench, a spiral notebook, and a tablet pulled up with a reference photo of a similar build. A hand-drawn, dimensioned sketch worked out the rough cabinet layout before any plywood was cut. It’s a small step, but one that pays off the first time a cutout needs to line up with a saw’s base plate.
A Rolling Base, Built to Actually Move
The whole point of this station is that it isn’t fixed in place. The base is a 2×4 frame with a locking caster bolted to each corner, built and tested well before the cabinets and saw bay went on top of it. Locking casters matter here. They let the cart roll freely when it’s being repositioned, then lock down solid so the saw isn’t sitting on a base that can drift mid-cut.
Building the Cabinet and Storage
The storage side of the cart is a cabinet carcass with a drawer, a door, and open shelving built onto one half of the base, giving the station somewhere to keep offcuts, hardware, and shop supplies without needing a separate cart nearby.
The Saw Bay and Tool-Storage Towers
Rather than boxing the saw fully in, this station backs it with an angled OSB “hood” that catches material and dust behind the cut without enclosing the saw on every side, and flanks it with two tall cubby towers: narrow vertical compartments sized for tape measures, drill batteries, and small hand tools, so everything needed at the saw stays within reach instead of buried in a drawer.
An early dry-fit, the saw simply set on top of the cabinet before the hood and towers were built around it, shows how much the finished bay changes the feel of the station once everything is in place.
Finished and On the Move
The finished cart was photographed outdoors against a cinderblock wall, a clean, undistracted setting that shows the whole build at once: the saw bay and tool towers up top, the drawer/door/shelf storage below, and the locking casters underneath it all. Sam, Jeremy’s dog, made sure to inspect the finished piece before it went back into service.
Related Shop Projects
This cart shares a shop with a couple of other projects worth a look, including a separate stationary miter saw station with a boxed saw bay and built-in dust collection, built into a fixed spot in the garage rather than on wheels. Each is a standalone build. The two aren’t the same station photographed twice, and this post covers only what’s visible in this project’s own photos.